Ornette

You are correct, IMHO. There are in fact "synergies" that need to be paid attention to, and it's not magic. Some vendors make real...

Oh man, don’t get me started on the anti-expertise, anti-institutionalist, anti-science attitude that continues to spread these days…...

I can't go into all the details presently. As for popularity, the P150/600 RS has been more popular than P400/1000 since it was...

I will have to revisit the noise measurement to verify the 25uV figure at 30dB gain. But I can assure you the noise is low at higher...

Good questions @Oniiz86 We did measure this during testing but I don't have the same noise measurements at maximum gain at hand now. But...

He has only reviewed the P400/1000. We have measured the P150/600 RS ourselves of course and let us know if there's anything you want to...

A teaser of our next amplifier.

Exactly. We rather want to focus on areas that are potentially an audible improvement, on high build quality for a long life span, and...

But it could have been. This escape was due to a lack of testing. How many other amps have been sold, that weren't tested don't fulfill...

This doesn't go with the rest of your post. Listen, you are getting ultra low cost implementation of these amplifiers. You can't take...

It doesn't need to a be a dyno test but a good quality control that minimises such issues. For example for a decent amp I would...

And nobody needs to accept that. That is not the issue. The issue is are we expecting the car manufacturer run every single car on a...

Yeah, that fundamental problem with those 50 year old AB amps you revere so much. Thermally unstable performance. ;) Many? Based on? Why...

Of course. That's why I asked Buckeye how he determined what percentage of amps to test. Not possible to do without establishing MTBF...

But that doesn't matter. It is not how heatsinks work. When the heatsink is cold, the power is just dumped into the thermal mass of the...