neutroncode

NConfigurator 1.8.9 is released. Release notes: https://forum.neutroncode.com/viewtopic.php?f=11&t=7458 It removes Digital Headroom...

Firmware 65 is out and fixes discussed issue with Preamp and user volume. Many thanks to @OHtaru for testing the pre-release candidate...

Thx a lot for clarification. Will do that.

Sorry, missed your proposal within active discussion probably. Technically, it is the volume level of DAC V1 at which ALC kicks in...

Your software can send data stream with a higher precision that leads to a less quantization noise and apparently 32-bit data bears 8...

In Qudelix app, do you mean Headroom option? It gives me 3 variations: 0 dB, -6 dB, -12 dB and works like a fixed-level Preamp in my...

Could you please clarify what mode do you mean (sample bits selection?)? DAC V1 does not have specialized driver but all modern OSes...

This is really confusing. And this behavior has caused me trouble: the volume of all music has increased. This forces me to use a small...

It is a new behavior of the volume in relation to Preamp. For example, let's set EQ 1kHz band to for example +10 dB then we effectively...

Firmware 64 + NConfigurator 1.8.8 are out! Firmware 64 release notes: https://forum.neutroncode.com/viewtopic.php?f=10&t=7453...

This bug is now fixed in NConfigurator 1.8.7: https://forum.neutroncode.com/viewtopic.php?f=10&t=7436 To make profile recognizable -...

It is normal behavior because PEQ works in a digital domain and we shall assume limitations. If you design EQ preset and listen to...

Firmware 61 resolved the noise issue. I have not noticed any noise anymore as long as the level is below 0dBFS. Filters with any gain...

50 dB gain works now with updated firmware :)

It depends on your listening scenario. If you do not listen with a very high volume then Low Impedance & Low Output will give high...