Recent content by nai

great!:D

If the room frequency response has several large valleys, low distortion and low compression is meaningless So, first of all, the frequency response is flat

For the time being, multi-sub integration solutions, such as Trinnov, antimode x4, glm，dirac automated testing will not be very good, it is best to manually optimize

The w371 did not all take over the 8351 or 8361 low-frequency unit, so the actual performance of 8361 + w371 will be quite a bit stronger than 8351 + w371, especially similar to Hans Zimmer.The 8361 alone and 8351 comparison is estimated to be similar, the 8361 low-frequency advantage will be...

w371 improves two frequency bands of one, one is 100-300hz, other is 20-100hz. 100-300hz w371 is mainly to solve the sbir problem, this band belongs to the key band, the problem of this band is solved, the impact on the sound is huge. Therefore, one + w371 will sound very different from the...

A large amount of basf g+ melamine is used:)

This is my 12 square meters of frequency response curve, distance 2.2 meters, 8361 + w371:)

w371 has 5 modes, the most common mode is to use 4 low-frequency units to smooth 23 ~ 300hz, to obtain a flat curve in this range, like as multi-sub

one+w371 shows more of 23~300hz, w371's 4 low frequency units bring array speaker characteristics(like as subwoofer array ), rather than the cardioid characteristics

one + w371 and 8c cardioid difference is very big, w371 brings 4 low-frequency units, 20 ~ 300hz, after dsp calculation, almost completely flat curve and sound, cardioid only improve 100 ~ 300hz sbir, below 100hz is no help, far from doing the level of w371. You can see my test specifically...

[8361+w371 and a lot of melamine foam:D Amazing sound！

Even without counting the advantages of the point source, 8361+w371 can automatically take care of the most difficult acoustic problems below 300hz, which no one can do yet, including kii and 8c

Without w371, 8361 is also a traditional speaker. w371 can get rid of the room to the maximum extent.:p

I used to have mm26, mm12 and ms12, the low frequency is very powerful, but still belong to the traditional speakers, highly dependent on the room acoustics. I replaced it with genelec 8361+w371