When measuring a DAC, this can only be done by digitally volume control the DAC chip itself. Not all DACs have such volume control available. But even in those in which it is available, adjustments inside the chip lead to an increase in THD. For example, when reducing the volume of the EC9038Q2M...
Can I ask for one change? When trying to perform the DSD test, it turned out that the signal going to the DAC was too large and was causing an overflow. Is it possible to reduce the output voltage of the DSD from -0.5 to -3 ...-6 dBFS?
May be. I know for sure that DO100 uses two clock generators. One with low jitter and the other with higher jitter. Why this was done, I don’t understand. Any of the clock generators can perform its functions on the full frequency range.
SMSL are cunning :)
DO100 has two clock frequency sources: asynchronous 100 MHz from a clock generator for frequencies 44.1-192 kHz and synchronous 44.1*1024=45.1 MHz or 48*1024=49.1 MHz from a frequency synthesizer for frequencies 352-768 kHz or DSD. Since most measurements are made at...
Replacing the two OPA1612 I/U operational amplifiers with an OPA1656. When I disassembled the DAC and looked at the circuit, I saw that the I/U op-amps operate in current modes close to the limiting ones. They are loaded with two DAC current channels, an RCA adder and an XLR load. Since the E1DA...
Immediately after purchasing it, I opened it up and modernized it a little. Therefore the warranty was voided. Well, I was interested in repairing it myself :).
My DO100 also stuttered. I had to replace the 100 MHz crystal oscillator. Perhaps SMS received a batch of defective generators. This is an SMD chip with dimensions of 3.25 * 2.5 mm. You can buy it on AliExpress for little money: 3$ 5 pieces. Before replacing the crystal, my DAC stuttered...
It is not always so. I have very average audio system with inexpensive china DAC, DIY D class amplifier and 3-way Speakers 150 Watt power and 91 dB sensitivity. I am 56 years old. But i can hear the 3 kHz 96/24 signal, which I turn on/off using the play/pause button on the player. From a...