Mario1969

Topping does not release the new firmware officially ...... it is possible that they have so many fixes that the next one will be...

When I read about problems people have with the DX5II, I think either I'm lucky or everything ahead of me. Actually, since the last...

One of my headphones is audibly quieter on one side, so I use this option to compensate for the volume.

I don't know if it's faulty, anything is possible, but it's very likely that it's a software problem. I've read a few stories on this...

If you've already done it, there's no point in doing it again.

I suggest you reinstall the firmware, even though you have a new one.....

ok, everything is clear... we had this problem some time ago... it was an old version of TOPPING TUNE NEW <<<<< LINK

one more important thing... V5.74 driver for most of TOPPING DACs LINK

I might know what's going on... try this... after you turn off DX5, try closing TOPPING TUNE as in the picture, turn on DX5, reopen the...

To save EQ settings in DX5II you must use TOPPING TUNE .. USER CONFIG not LOCAL CONFIG, and set ENABLED - PEQconfig in DX5, also update...

it's not entirely true that the CLASSIC VU meter set to +10dBu in the DX5II shows a digital "0" this meter shows when the device is...

Any AUDIO digital device will clip after exceeding the digital "0" unless it has a built-in LIMITER. The DX5II doesn't have such a...

The VU meter shows the volume (intensity) of the audio signal; it has nothing to do with the quality of the recording. In the analog...

you can check this using a DXII CLASSIC VU meter set to +10dBu .... see the photo

Have you checked the input level? The DXII can distort the input signal. Some time ago, I was listening to Spotify and I heard...