knevgen

My understanding is that the 192khz is a limitation of the DSP, i.e. it applies to whatever source you are using and wherever the PEQ...

Mine unit came with 1.87 firmware (or something like that) I updated it to the latest 2.07 I have a question regarding Topping Tune app...

Pretty much, yeah. And my head is not that big and i dont have gorilla hands. It snapped inside where the screw goes.

They made this part of the mount from metal on Moondrop Skyland. I guess they thought it's going to be an improvement.. One of those...

Exactly. I would not need to reconnect the headphones in foreseeable future. I suppose, for 8 ohm Moondrop Para it is preferable to...

AFAIK, there are no known reported issues with the 4-pin XLR headphone output.

XLR and 4.4mm are connected electrically. No difference which you use. If you are concerned about about the 4.4mm shorting when...

Did anyone experienced issues with XLR output? 2m XLR to 2x3.5 is the balanced cable with fastest delivery i found so far. I do not plan...

I am willing to give the headphones another go.. They are original Para, but there arent much difference from Para 2 - i think Cosmo ear...

Since i cant hear any ground noice i will just keep using USB then.. Will be picking up my DX5II tomorrow evening.

Hello, i assume you are using SPDIF not from PC? If the source is PC.. I figured, with USB you get access to Topping Tune and Dolby...

After some thought, this might be a better choice than separate A50 III amplifier. Reading about possible issues - I will take a...

Impossible to say. Sometimes 20m runs are fine and other times a 2m run can already make trouble. Depends entirely on the surrounding...

Yes, the A50III is for for that purpose. Balanced input can eliminate mains hum and other common-mode noise that especially long RCA...

Thank you. The RCA length i will need to run from AVR to listening position with amplifier are about 8 meters give or take. Do you think...