Stickers? I ain't got no stickers! I don't need no stickers! I don't have to show you any stinkin' stickers!!
:D
Probably never at this point. :facepalm:
Correct, the Bedini BA-801 is currently driving the MLs as when I added rear surrounds, it would not allow me to have the rears as the only self-powered speakers to achieve a 7.0.4 configuration (the tactile transducer is not considered a sub.) I did not want to drag out the old amp and add it...
No idea. Depends on the model and impedance curves. I drove Martin Logan Sequel's (spots below 2.5 ohms, 1.6 ohms min) with the X3800H without an issue, would still be doing so but to have 11 speakers I was forced to add an amp to drive the fronts. I had hoped for some certainty before...
I thought this was a reasonable opinion.
3 days later and now the 3800 is gone and the DAC sounds "clinical"? TI DAC has nearly identical specs to the AKM DAC at 3.3V supply voltage. It's only when you raise the rail voltage to 5V that the AKM is significantly better THD+N -wise. (TI 5102A is...
I stopped reading 2 pages ago. I asked similar questions earlier in this thread. I was told my posts were quietly being removed and that I might be banned if I didn't shut up, so I just said to myself "not my playground" and have mostly stayed silent here.
I would equate the "poor" measurement to my ability to hear ultrasonic energy. I can likely feel a wheel vibration, but no matter how hard I try, I can't hear a 25kHz tone.
The Bedini amp is a 35 year old discrete amplifier design with several feedback tricks discussed in the marketing blurb for reducing harmonic distortion. I believe most of the distortion reducing techniques are built into the IC amplifiers used in modern receivers. The class "A" (notice the...
Reminds me of spec sheets like this:
Between no THD specs @ 4 ohm rating (though at least it's rated 200W 20-20k) and "sonic quality is subjective", I can hear heads exploding now! :facepalm:
In spite of said discrepancies, this amp works exceedingly well to unload the tougher to drive load...
I use these tiny Gemstone speakers for side surround (shown below) and rear surround. Room is small (14' x 12') though with vaulted ceiling. The two drivers within the GS speakers are angled apart so it helps ensure sound gets to all listeners, even though they are fairly close to the seating...
I feel like they did lower the surround boost in Dynamic EQ with latter firmware updates, though I didn't measure before/after, I just don't notice the surrounds being noticeably boosted now. The reason Dynamic EQ exists is human hearing can't locate sounds from behind as easy as from in front...
There are separate low-pass crossover and gain settings specifically for the tactile transducer.
Also, transducer gain can be adjusted on-the-fly (+/- 12dB) for each input source when gain is adjusted in the Options menu.
I find it to be extremely useful, especially whereas I don't have any...