Recent content by Hifisound

Why ? What you said "Theres no proper line out, the Pro acts more like a pre amp. Connect the RCA outs and the volume control still works." is true , right ?

I wonder why Fiio didn't explicitly call it a pre out then ? Any caveats if using it as pre for JBL actives (LSR306) ?

Hi @Tom Danley , And 60x60 was chosen for home speaker instead of 90x60 (which even the Danley cinema line also uses) for certain specific reasons ? Thanks!

Interesting! Though as a first home model, I thought they would go with their 90 x 60 horn as even their cinema line (https://danleycinema.com/) has mostly 90 x 60 horns (esp the small room which is close to home )

I checked with them, via email, and the coverage pattern is 60 x 60. I wonder if 60 would be too narrow for home setting, making it headphone like as @Juhazi mentioned above

Measurement of this would need horizontal & vertical dispersion plots for both sound and water :)

Did you get a chance to measure them ?

No probs. I did try searching by same publication (and by going to model specific docs on https://www.audiopro.de/ but it takes to bonedo.de review which no measurements) but didn't find any... The SRX835 and PRX835 comparison would also be interesting, latter being wider dispersion

You sent me back to the same place I began my question with :) :) I was asking about PRX835 https://jblpro.com/en-US/products/prx835 Those measurements are for SRX835

Anybody seen/found measurements for JBL PRX835 ?

Thx. Will an active one be better ? Or will it be more noisy ? I am also wondering if I should use active DI for all 5 LSR308s ( even for nearer LCRs) to have better gain match between AVR pre out and 308s

The cable dealer has recommended me this for the rear speakers which require 37 ft length https://dbxpro.com/en/products/djdi this is passive though

The reason I got LSR308 was they were even cheaper than Elac B6.2 here in India. Yaa turning them on is one hassle but I expect better SPL handling from them in my 22’ x 14’ ft room. I tested them and didn’t find the hiss to be an issue unless listening very close to the tweeter. ( for 4 atmos...

Yes, the DI box can be very very close to AVR. Behringer is one option , other being DBX DI box. I will check what other options are available

I did get the LSR 308s x 5 Any input on using a DI box for surrounds ? As one of the length would be 37ft. Any risk of quality degradation ? Thanks!