haavind

properly zeroing my multimeter before doing resistance measurements on R_sense, R_ref and DC coil resistance, and measuring R_sense...

I bought a pack of lower value resistors with better power handling. I'm now using 27 ohm R_sense and 7 ohm R_ref. I soldered my wire...

this is a single 256k sweep now. Before I was doing 4x512k.

It turns out my microphone input gain setting was waayy to high :facepalm: Thanks for your critical questions I suppose :oops:

It seems like the blue part of the cable is an especially good 50hz antenna :confused: 20-30-40 dB more sensitive than different...

If I set it higher, REW complains about input clipping. If I overrule the input clipping, the result comes out wrong. Wrong values and...

Good luck decoding this mess :p

I've tested the drivers cold and on different days and different times of the day. It doesn't vary that much from the new breakin curve...

I don't know. I was hoping someone wise here could enlighten me because this was the opposite of what I expected. A softer spring should...

pre-breakin (darker colors) vs post-breakin (brighter colors) impedance plot. The general trend is that the resonance peak shifted up...

I see. What metric are you basing that on? Yeah you are right. I used the built in calculator in the TS module in REW and punched in...

I would never recycle my old wooffer Even if he barely woofs anymore My measurement rig is not superhigh fidelity. some 50hz mains...

Finally got my wiring harness and buggy mic soundcard to work ;) Here's my impedance curves, yellow is free air, purple is 7g added...

Not really sure how. Also, not really sure how I would interpret the result. TS is still a little bit mysterious to me. What would a...

I have a handful (4) of old 8" woofer elements from my old Dali AXS8000 and I am looking for something to do with them. The model number...