Recent content by estebanelequente

  1. E

    Am I Trading Watts or Caught in the Upgrade Cycle?

    I never ended up biamping them. The 400w from the sunfire was more than enough and they sound great on that amp. I did a lot of research and without exception I found that it would provide little to no benefit to me.
  2. E

    Am I Trading Watts or Caught in the Upgrade Cycle?

    I found a steal on a sunfire cinema grand in great shape for $500 I think I’m going to pick it up. It does 400wx5 into 4 ohms. I’m debating passively biamping my mains with it and running my center with it then using the anthem for my rear right and left. Thoughts?
  3. E

    Most important speakers after LCR

    I have a 7.2.4 system I currently have a 2ch amp on my front soundstage. On Monday I’m adding a 5ch sunfire amp. My debate is 1 whether I should passively biamp my mains Martin Logan theos. And even if I don’t biamp after my mains and center which speakers in the system will get the most benefit...
  4. E

    Am I Trading Watts or Caught in the Upgrade Cycle?

    I am 13.5ft away my room is 17x15 the peak I measured through a db meter on my phone was 95db it was loud but not too loud.
  5. E

    Am I Trading Watts or Caught in the Upgrade Cycle?

    I’ve never heard of that. Excuse my ignorance, I’m. Or challenging you, but if you could clarify. If I had only 3 speakers clipping and they were the speakers with the most difficult load and I’ve already eliminated clipping on 2 of them by upgrading my amp on those 2 how would I not eliminate...
  6. E

    Am I Trading Watts or Caught in the Upgrade Cycle?

    Here is my situation. I have a 7.2.4 Dolby atmos system. My front soundstage are all 4 Ohm Martin logan Speakers. Before you tell me I am listening too loud, I know I am, but that is how I like my movies. I have noticed that when I whatch a particularly dynamic movie my front soundstage clipps...
Top Bottom