epping4est

Agreed, but neither PLR nor PSR algorithms would measure more than the delta of the recording's (raw) quietest and loudest audio signal...

Nice. Even nicer if that were the norm!

c.f. A Beginner's Guide to Dynamic Range in Audio Production As shown, the Dynamic Range (DR) is the difference between quietest and...

Why provide as evidence the database sorted by Average DR (descending) rather than sorted by Maximum DR (descending) as was given? I...

Correct, as was stated later in this thread, where IEC 60268-5 is the referenced "standard":

The Dynamic Range DB represents a very small fraction of all recordings, but anyway lists quite a few recordings having a DR of more...

Yep, that [knob] would do it. :p

The two salient configurations are 1) Vertical Bi-Amp; and 2) Dual-Mono Amp: Bi-wiring a bridged M23 requires that the amp-ends of...

where "They" = M33 & M23 M33: 435 x 133 x 396 mm (17 1/8 x 5 1/4 x 15 5/8 ”) M23: 435 x 133 x 381 mm (17 1/8 x 5 1/4 x 15 “) i.e. Same...

Subjective listening ... I have since listened for several hours to all three of the above configurations and bridged sounds best. I was...

Glad this link was listed here. I check it for almost every older CD I purchase to make sure the one I'm getting wasn't submitted to the...

I'm late to the party, but I think some of you may be interested in the Dynamic Range DB [where DB = database]. The given link presents...

@Vladimir Filevski - Check out 'violent agreement'. I also noticed that you altered [added to] your post after I made my reply. There's...

Ah, so we were in violent agreement all along. :)

:) Don't do that! Let's get back to known facts rather than theoretics ... Even as I type this reply I'm listening to my PL100-3Gs...