Recent content by cany89

Has anyone got the chance to compare 4329 to 708? Since 4329 measures pretty well, ha built in streamer, it’s definitely an interesting choice for me. If I buy 708, I will have to use Streamer + DAC (MBP + RME Adi-2) What say you guys :)

Guess I'll have to fiddle around and see how it sounds best (regarding high-pass).

Hi All! Back again with interesting questions - I guess :) I'm going to pull the trigger on 2x SVS SB-2000 Pro sealed subwoofers. Right now I have 8-inch no-name subs sitting flank to my mains. Mains are bookshelves that start to roll off around 150 Hz (they are near field, I'm using mid...

Sure! It’s combination of 2 Harman curves. Bass section is from older where it was less elevated. Try it and if you think you need more bass, you can just add few dB below 120 hz with low shelf. Pk - 35hz, +2dB, Q=1.41 Pk - 528hz, +1.5dB, Q=2.3 Pk - 890hz, -1.5dB, Q=3.5 Pk - 1224hz, -1.5dB...

@JRS Directivity starts after 100 cycle. So if your 15’ woofers are crossed below that, I don’t think you need to worry about this. I’m just guessing here btw :)

Thanks @DWPress , I was reluctant to sacrifice my second Adi to this but I will try again to see if it works.

I know! It’s all because I’m trying to use studio monitors without their dsp or amp pair that applies the filters… No need for delay is good news!

That’s bummer! I will try 2x Adi-2 once more than. What do you think about delay issue? Does 12-13 inch subs need delay on mains to match he phase?

This is OK with current setup but with cabins like SVS 2000, I will have to place the 705s on top of subs to match this distance. Will vibration hurt the 705s?

That is actually correct. It sounds like 3 way. But I want to add crossover to my mains. Either via PEQ or just xover function…

@abdo123 thanks for the suggestions. Unfortunately my system is locked. I got macbook pro with RME Adi-2 as DAC + Pre. I’m 100% happy with the sound. I managed to get convolution filter for my 705 as well. Currently applying the filter with vst on pc out - before DAC. I measured the 705s and...

Hi everyone! I’m looking for a device that takes the XLR out of my preamp, split it to 4 XLR (2x for bookshelfs so XLR to power amp, 2x to active subs XLR or RCA). Then I need crossover, delay, and convolution filter for each output. So that I can set delay to bookshelfs if needed, and use...

You can buy a calibrated measurement mic (like umik-1) and run the simplest test possible to get an in-room response of your speakers. It will tell you exactly how well bass is below 200 Hz will integrate and more. (Although I believe you are talking about anechoic chamber measurements, I still...

76' JBL L50, Pioneer U-05 DAC + Pre, Counterpoint Solid Amp. I got all used from different sellers in a few months. Blow away my Elac's + integrated setup. Realy had the WOW factor when you were listening to rock music.

I bought a Siltech XLR cable. Probably the cheapest they offer but expensive for any sane person! I definitely regret it but at least I like the look :/