typo on the - the three pins are all ~5v
Here are the Amp on measurements
with the j6.3 to j6.9 connected
J6.1 to j6.3 = 4.5V
j6.2 to j6.3 = 5.2V
j6.4 to j6.3 = 6.1V
really sorry - first measurements the amp was off
Here are the Amp on measurements
with the j6.3 to j6.9 connected
J6.1 to j6.3 -4.5V.
j6.2 to j6.3 = .5.2V
j6.4 to j6.3 = 6.1V
Hi all,
I'm at a loss to figure out what's wrong with my Hypex NC500mp build but I'm not getting any sound from it. I have a balanced input that I've verified works fine through my Crown D75 but when I swap in the NC500MP I get nothing. These units have the built in power supply and I"ve...
Well - finally fired up the amp to test it and alas no sound. I hear an audible click when turn the on on which I assume is the amp going from standby to on but no sound is coming through the amp. I checked for any DC on the circuit and only see a few Mv. Anyone have any ideas for what I...
Another question for you guys. I bought a cheap case on ebay - the case has is thin aluminum and has "rails" on the bottom. Is that an issue for the heat sink/cooling?
NTK - thank you for the diagrams and the assurance that I'm on the right track. Wasn't 100% sure on the signal to case. I think I'll use the "extra" ground pin on the Neutrix connector unless I'm told I should make another connection to the case. Not as pretty as a lot of builds here but it...
HI all,
I'm building a NC500MP mono amp to power a Rel Britannia sub. I'll be using a MiniDSP Flex for crossover and DSP. Amp is almost together but I want to check-in to be sure I understand the singal wiring correctly. On the XLR to Hypex board(J4)connection I'm using shielded microphone...