I got my VTV build, and if it wasn't already confirmed, its 100% a Ghent case. I wanted my face plates to match and originally thought I would just order a second VTV one, but they wanted $50 so instead got a plain one from Ghent for $35 (including shipping).
I am new to amp building (and arm chair electrician'ism to boot) and curious why the Ghent / VTV boards are wired slightly differently. Both are using pins 1-3, but Ghent cable is also using pins 5 and 7 while VTV isn't. Having voltage regulation sounds like a good thing, is there any reason VTV might have excluded this, and should I add these wires?
View attachment 116032
Ps. As for build quality, it all looks fine. The faceplate was screwed on rather hard, almost stripped the screws getting them out and the cable positions have already been discussed. And it looks to be using a filtered IEC inlet which may need to be replaced