Hi everyone!
I'm looking for help with a serious problem with my SMSL SU-8 DAC.
As You can see on
video my DAC S.M.S.L SU-8 V2 hits 3.15V on XLR output with almost every change made by remote, as: input/source, pcm filter, sound mode. It happens even when volume is set on 0, and even without any input signal! It happens also when I'm playing music witch bitrate changes. As a result it makes a very loud "clicks/pops" in my loudspeakers - I'm using very efficient loudspeakers (92dB), mono aplifiers without pre-amplifier, and in my case my dac is my pre-amp, so 3.15V signal makes literally an earthquaqe in my room.
It's not only annoying, but also i'm really afraid about my mono-amps and loudspeakers, the click/pop is just so loud that i'm afraid about my neigbours too. And about me because of my wife...
Anyone has similar issues with SMSL SU-8 DAC?
Set desription: SMSL SU-8 V2, firmware 1.6, XLR cables with shield connected to both plugs m-f, foobar 2000 and flac files. When playing music sound is clear without disortions, just those vero loud and annoying "clicks/pops" on every change.
Nightmare.
In that case i should turn off my monoblocks before I make any little change in my DAC settings, and turn them bac on after changes were made, which is just stupid.
Thank's in advance for any help!
enak
p.s. pls forgive my poor english
[/QUOTE]