So, long story short. I did get the Revel F206s.
I used a pair of DIY speakers with 10" woofers, and I DO miss the lower registers.
A good friend sold me a mint M&K MX-125ii sub. I cannot afford anything else due to having bought the Revels. But from what I've read, these were extremely nice subs.
Anyway, I'm looking at integrating them to my towers.
There is a corner right in the center of my speakers, to the back. I want to place the sub there.
The sub is going to be away from the speakers. About 1.2 meters away from each, equidistant.
From what I've read and seen, the only proper way to integrate subs and speakers would be using a MiniDSP, EQing as much as possible and setting delays on the mains.
I was just wondering if this would be the best way.... opinions would be welcome.
Thanks!
I used a pair of DIY speakers with 10" woofers, and I DO miss the lower registers.
A good friend sold me a mint M&K MX-125ii sub. I cannot afford anything else due to having bought the Revels. But from what I've read, these were extremely nice subs.
Anyway, I'm looking at integrating them to my towers.
There is a corner right in the center of my speakers, to the back. I want to place the sub there.
The sub is going to be away from the speakers. About 1.2 meters away from each, equidistant.
From what I've read and seen, the only proper way to integrate subs and speakers would be using a MiniDSP, EQing as much as possible and setting delays on the mains.
I was just wondering if this would be the best way.... opinions would be welcome.
Thanks!